User Manual

Section 5 Suggest parameters for engraving and cutting of materials
Table1 S6 engraving machine common material engraving parameter table suggestion
Material
Quality
laser Energy(S-Mx)
Speed
engraving
Basswood
5-6
400
1000
Hardwood
5-6
400
1000
Bamboo
5-6
400
1000
Acrylic
5-6
600
1000
Kraft paper
5-6
400
1000
Mirrors
5-6
400
1000
Paited Stainless steel
/aluminum alloy
8
1000
200
Table2 Cutting parameters for common materials of S6 engraving machine suggestion
Material
Engraving times
Quality
laser Energy(S-Mx)
Speed
cutting
1.8mm Basswood
3
6-8
1000
400
6mm Hardwood
15
6-8
1000
400
1.8mm Bamboo
3
6-8
1000
400
2.8mm Acrylic
12
6-8
1000
400
Kraft paper
1
6-8
1000
800
The meaning of the software parameters in the table:
Repeat carving rounds
Quality laser Energy(S-Mx) Speed
8
Suggestion for engraving and cutting:
1. When engraving, you can initially test the parameters, engrave the effect, and then formally engrave.
The two parameters of pattern preview and quality are very important when engraving. Generally use
Line to line mode.
2. When cutting, try to increase the quality and energy, and slow down the speed appropriately.
Mode generally used: Vectorize/Centerline
Note: This is a very conservative parameter recommendation. The actual number of times needs to be
adjusted according to the actual materials and test results.