User Manual

5. Position the preview engraving pattern position
Regarding how to locate the engraving pattern, that is, how to make the pattern engraved in the correct position of the
engraving object, this is an important topic for laser engraving machines.
The S6 engraving machine uses the click to center position to make the laser to center of the pattern, at the same
time, move the engraving object to make the engraving object coincide with the center of the laser, so that the axes of the
two have coincided. Note that at this time, try to observe the outline of the engraved object and make it parallel to the
outer outline of the laser.
The next step is to determine the specific engraving position, the axis has been coincident, by scanning the outline ,
you can know exactly where the laser engraved pattern will be and the size of the engraved pattern.
The outline of the engraved pattern previewed in the software is the actual scanned outline, and the position of the
engraved pattern can be previewed through this operation.
Scan the outline, you can preview the precise position of the engravd pattern
Section 4. Start carving and control during the carving process
1. Click to start engraving, and fill in the number of repeated engravings here
2. There are four forms of emergency stop: pause in the lower right corner ; cancel all
data immediately ; stop engraving , or directly turn off the power switch on
the control box is also an emergency stop method.
3. The laser energy adjustment, line width and speed adjustment during engraving are as
shown in the figure below
laser Power,Linear,Speed
adjustment
7