User Manual

4. Move the laser head position, laser focusing
S6 does not have a limit switch, so the origin (0,0) position of S6 in the LaserGRBL software is:The
point which the axis of the laser is aligned when power on and software lock . In other words,
you turn on the power supply, connect to the engraving machine, and then click the software lock .
At this time, the laser axis position is the origin (0,0)
Because we will use a centered laser in the next step to determine the position of the engraving pattern,
if the original position of the laser is improper, it may collide with the laser, so it is recommended to
move the laser to the middle of the frame every time before engraving the pattern.
The S6 series engraving machine uses a fixed-focus laser + sliding device to adjust the laser so that
the laser focus is irradiated on the surface of the engraved object. It is divided into the following steps:
a: Place the fixed-focus column on the surface of the carved object, and slide the laser down so that
the laser shell is in close contact with the 20mm fixed-focus column.
b: Tighten the fixing screws of the laser and remove the fixed focus column.
Before each engraving image ,
Move the laser to the middle
of the frame.
Click the center button
Place the 20mm fixed
column on the surface
of the carved object
Tighten the fixing screws,
And remove the fixed
focus column
Adjust the position of the sculpture,
Make the engraving object and
the laser shell outline parallel,
while the center point also coincides
Move the laser to the center
of the frame again
6