Owner`s manual

ManualsBrandsSCS Industries ManualsHome building and DecorPortable and In-Ground Spas

FILTER CARTRIDGE REMOVAL AND

CLEANING INSTRUCTIONS

Turn the power to the spa off, then proceed as follows:

1. Push down slightly and turn filter basket counter-clockwise to unlock, then

pull the basket and weir out.

2. Carefully pull up the filter cartridge and bring it out of the spa.

3. Rinse cartridge using a garden hose. Rotate and separate filter pleats while

spraying water to remove all debris possible. Let the filter dry and then look

for calcium deposits (scaling) or an oil film. If you find these, you will need to

deep clean your filter cartridge with a “spa filter cleaning” solution to break

down and remove mineral deposits and oils.

4. To return basket and weir, insert and rotate clockwise to lock into position.

Then, turn spa’s power back on.

NOTE: Replacement filter cartridges are available from your Caldera dealer. Refer to

the back of this manual to determine the appropriate size for your spa.

SPA LIGHT COLORED LENS INSTALLATION

Colored lenses are included with the spa light. To install or remove lens, push ON

or pull OFF of the spa light.

SPA LIGHT BULB REPLACEMENT

1. Turn OFF the power to the spa.

2. Remove the equipment compartment access door.

3. Locate the rear of the spa light (see “EQUIPMENT COMPARTMENT (JET

PUMP SIDE)” ).

4. To remove the bulb, turn it counter-clockwise 1/4 turn, and remove the bulb

from the socket.

5. Replace the bulb by reversing the above steps.

CAUTION: The replacement bulb must be the same rating as the factory installed

bulb (replacement part number 37-0101 Fk2, package of two; or standard

automotive type #912).

DIVERTER VALVE MAINTENANCE

If your spa’s diverter valves become difficult to turn, it is likely that sand or grit has become lodged

inside the valve body. It is very important that this debris is removed as soon as possible to avoid

damage to the valve. To accomplish this, follow this procedure:

1. Turn off power to the spa.

2. Remove the diverter valve’s handle by pulling upward while rocking it back and forth.

3. Unscrew the cap ring.

4. Remove the valve body by pulling it upward.

5. Wipe the valve body and the interior walls of the valve clean.

6. Lubricate the valve body with a waterproof lubricant available from your Caldera dealer.

7. Reassemble the valve and turn on power to the spa.

MAINTENANCE

FLOATING WEIR

BASKET

FILTER

CARTRIDGE

SUCTION

LINE

PLEATS

SPA LIGHT

LIGHT BULB