Owner`s manual

23
OPERATING INSTRUCTIONS
To display the set temperature for three seconds, press either WARM or COOL. To change the set temperature while the set temperature is displayed, press WARM to
increase or COOL to decrease the set temperature. An LED between the WARM and COOL buttons will illuminate whenever the heater is activated.
Jets Control
Pressing the Jets button (on the Kauai or Martinique) or the Jets 1 or Jets 2 button (Geneva, Niagara, Tahitian or Hawaiian) turns the single speed pump on or off. An
LED above the Jets button will illuminate whenever the Jets button is activated. The pumps automatically turn off after operating for 30 minutes.
Air Jets Control
Press the Air Jets button to start or stop the air jets. The air jets operate for 15 minutes, then automatically shut off. An LED above the Air Jets button will illuminate
whenever the Air Jets button is activated.
Light Control (Mood Light Only)
The Light button allows you to select from three different settings. Press the light button once to turn on the brightest setting. Press a second time to turn on the
intermediate setting, and again for the dimmest setting. Press the touch pad a fourth time to turn off the light The light automatically turns off after 4 hours of operation.
Light Control (Interior Fiber Optic Optional)
If your spa is equipped with the aftermarket interior spa fiber optic system, the light button operates the fiber optic light as follows:
Press once to turn on the light and rotate the color wheel.
Press again to turn off the rotating color wheel while the light remains on.
Then press a third time to shut both the light and color wheel off.
The light automatically turns off after 6 hours of operation.
Advance Mode Control
The Mode button is used to initiate advanced panel features such as the cleanup cycle, panel lock, temperature lock, and setting the automatic fiber optic light
(optional).
AUTOMATIC OPERATIONS
System Purge
The system purge operates in the following manner:
The air blower activates for 30 seconds.
Jet Pump 2 runs for 1 minute (on Geneva, Niagara, Tahitian, and Hawaiian models only).
Jet Pump 1 runs for 10 minutes.
This system is initiated 60 seconds after the spa is powered up, then operates once per day.
Summer Logic
The circulation pump, heater and ozone are disabled if the temperature regulating system detects that the water temperature exceeds the set temperature by 5 degrees.
The circulation pump, heater and ozone will remain disabled for the next 8 hours. After 8 hours, the functions will be enabled and remain active for the next 16 hours.
Upon completion of a 24 hour period the temperature regulating system will again compare the water remperature with the set temperature to determine if the cycle
should repeat.
Auto Heat
The heater will automatically activate if the water temperature is 20°F below the set temperature.
Interior Fiber Optic Light (Optional)
If your spa is equipped with the fiber optic light, it may be set to automatically come on for 6 hours every day. You must wait until the desired starting time before
activating the automatic mode. To activate the automatic mode, press + + within 3 seconds. This will cause the fiber optic light to
illuminate for 6 hours every night at the same time. To deactivate the automatic function simply press the same buttons again.
NOTE: Automatic fiber optic light is not enabled on power-up.
Cleanup Cycle
The cleanup cycle (used for water maintenance) will activate Jet Pump 1, run for ten minutes, then automatically shut off. To activate the cleanup cycle,
press + within 3 seconds.