Instruction Manual
53
3. Set weekly program
After complete setting of current TIME/DAY, below are the steps to set weekly program:
1. Press “
” button, the product enter into working status.
2. Press “ ” button, the display shows ”P“(the light of “P” in display will go on), it enter into weekly program
setting:
3. Press “ ” button, the display shows d1, press “ ” button to set to working day
(Monday-Sunday: d1~d7). Such as set Monday:
4. Press “ ” button, the display shows P1 as default, press “ ” button to set time
period (P1-P6).
Note : It can only set maximum 6 time periods for each working day,while setting any time and adjust
temperature. Follow step 5-7 below to set turn-on time/turn-o time/desired temperature for each time
period(P1-P6). Such as setting P1:
5. Press “TIME/ON” button, the display shows “00” as default. Press “TIME/ON” button one time increase
one hour to set the turn-on time (00-24 hours). Such as set the turn-on time 7:00 am
(As gure);
6. Press “TIME/OFF” button, the display shows the previous turn-on time by default. Press “TIME/OFF”
button one time increase one hour to set the turn-o time (00-24 hours). The “TIME/OFF” can not be
less than “TIME/ON”; When the “TIME/ON” is the same as “TIME/OFF”, the product enter into standby
mode; Such as set the shutdown time at 13:00 pm:
7. Press “ / ” button to set the target temperature (Temperature range 10-49°C);
8. Repeat steps 3-7 above, you can set the weekly program for the working day you want.
9. Then press “ ” button to conrm the setting.
10. To cancel the weekly program function, press the “ ” button again , the light “P” will go o. The weekly
program is o.
A B C D E
Note: After the above setting are completed and P program is working, press “
” button to check set
working day (d1-d7), press “ ” button to check time period (P1-P6), press “TIME/ON” button to check the
set turn-on time, press “TIME/OFF” button to check the set turn-o time.
Note: After the product power o, it needs to be reset
4. Set open-window detection
1. Press “
” button, the product enter into working status. Heating for a moment until stable.
2. Press “ ” button by remote control,light “ / 0°C” is on; The temperature display “23” by default. Press
“ / ” button to set target temperature. If temperature decreased detected, the product will stop
working. Then press “ ” button to turn on the product.
3. Press “ ” button again to turn o the open-window detection, the light “ ” will go o and the product will
resume to previous working mode.
Below is an example to set 23°C during open-window detection (Figure H).