Instruction Manual
52
2. Button
function same as which on control panel
3. Set current TIME/DAY (can set both under standby mode & working status): Press “ ” button for one
time, the display shows “12” as default, press “ / ” button to set current hour (00 to 23); press “ ”
button again, the display shows minute “30” as default, press “ / ”button to set current minutes
“00 to 59”
Press “ ” again to display the day of week, press “ / ” to set current day. (d1=Monday, d2=Tuesday,
d3=Wednesday, d4=Thursday, d5=Friday, d6=Saturday, d7=Sunday). Then press
“ ” button to conrm the setting. The displays show the content before the initial setup.
For example: Setting to Wednesday, 9:30 AM, please refer to the following photos:
Note: After the product power o, it needs to be reset, then press “ ” button to check the current time & day
in turn;
The timer set up period is 00-23 hours, 00-59 minutes.
To check the current time and setting temperature, press SET again.
2. Set temperature
During working status, Press “
/ ” button ,the display shows as default. Press “ / ” button to set
desired temperature (temperature range 10-49°C), press “ ” button to conrm the setting.
For example: The current ambient temperature is 15°C, when set temperature to 25°C, the display shows
as below:
Note: When setting temperature, it will use below working way:
1. Setting temperature – ambient temperature>2°C, working with high power (II);
2. 0°C <Setting temperature – ambient temperature ≤2°C, working with low power (I);
3. Setting temperature – ambient temperature=0°C, the cool fan will work for 30 seconds to blow out warm
air left inside, the product will stop work.
If you want to cancel the setting temperature, press “ ” key to choose the heating I or II, the product
will work without setting temperature. While the light “0°C” will go o, and the display will show “--”.
After continuous heating for 12 hours, the cool fan will work 30 seconds , the product will enter into
standby mode.