User Guide

14
Note:
If only wireless connection is available on the Remote receiver and Wifi Direct is used to
connect to the MultiBeam cluster, the Remote receiver will bridge its network connection to
the Primary’s network connection. If you want to modify the name of the MultiBeam cluster,
you should configure the cluster name for Remote receiver first, then the Primary. Otherwise,
the remotes will lose connection to network.
5. The MultiBeam settings will be configured successfully, and configuration status will be
displayed in the Feedback column.
Note:
Currently, mouse cursor is not displayed or not correctly displayed on video of Remote
receivers.
Be sure to switch the Remote (Multi-Function) receiver’s Display Sharing Mode to Single if
you experience video/audio streaming issues on those remote receivers.