User Guide

2.2 Setting up MultiBeam

The ScreenBeam MultiBeam feature is not enabled after the MultiBeam app is installed.

Proper configurations are required to make the MultiBeam feature work. This section

describes configuration procedures on SPCMS.

Note: Refer to the receiver’s user guide for details about how to configure a ScreenBeam

receiver on the receiver’s LMI.

To configure MultiBeam settings, follow this procedure:

1. Go to the Manage Apps page by clicking Manage Apps on the left pane.

2. Select one or more receivers on the Receivers pane, and then select Actions >

Configure.

Note: ScreenBeam 1100 Plus receivers that are deployed as Primary receivers must

have the MultiBeam feature enabled one by one, as a Primary receiver must have a

unique Cluster Name and a unique Multicast IP address. ScreenBeam Plus receivers

that are deployed as Remote receivers can have the MultiBeam feature enabled by

batch if these remote receivers connect to the same Primary (the same cluster name).