User's Manual Part 3

Screen Service SDT 501 UB-C ARK 1-T Operations
May, 2010 v 1.0 Page 3 - 18
3.4 JAVA REMOTE GRAPHIC USER INTERFACE
The Java Graphic User Interface, stored in the board File System, is downloaded to the local PC
every time the user connects to the board with a Web Browser. A proper Java Virtual Machine is
needed; refer to the Appendix B for a description of supported Java and Internet Browsers.
3.4.1 JAVA INTERFACE OVERVIEW
The following figure shows the main control switch of the Java User Interface. It allows the
switching between control pages for settings and monitoring the device.
Figure 2. Java main control switch
The following controls are provided:
System commands bar allows the enabling of the following commands:
• Connect: connects/disconnects the local machine to Ark1 system
• Save: allows to save the device configuration.
• Load: allows to load the last saved device configuration.
Figure 3. System commands bar
Operation pages bar allows to switch between the following operative sections:
o General: allows to enable the Stand-by mode through the LCD Button, to reset the
device and to locally download the *.jar file.
o Input: shows ASI and GBE input statistics.
o Modes Management and Seamless Switching: allows to monitor the RF input and
to configure operative modes (mode A and mode B).
o Modulation: allows to monitor and to set the DVB-T/H modulation parameters.
o Linear Precorrection allows managing linear pre-correction curves.
o AM/PM Precorrection: allows managing AM/PM pre-correction curves.
o Outputs: allows to set output parameters, specific for each operative mode, and to
monitor the hardware status.
o Network: allows the Network management and the RTP in/out parameters setting.