User's Manual Part 3

Screen Service SDT 501 UB-C ARK 1-T Operations
May, 2010 v 1.0 Page 3 - 122
3.15 OID
Any status and setup information has an OID (Object Identifier). The OID of the ARK1-T
system is:
• screenservice_ARK1r: 1.3.6.1.4.1.21678.188
iso(1).org(3).dod(6).internet(1).private(4).enterprises(1).screenservice(21678).scree
nservice_ARK1t(188)
3.15.1 SNMP tree structure
The SNMP tree structure is shown in Figure 26, after the node screenserviceBroadcasting
there is the node that specifies the device typology.
The screenservice_ARK1-T tree has 12 nodes and 1 leave.
The nodes are:
• Ark1t_SystemInfo: global description of the system.
• Ark1t_Mode: shows and manages board modes.
• Ark1t_Input: shows and manages inputs.
Note: In Ark1t_STV0 and Ark1t_STV1 nodes are housed the statistics of the digital
RF signal. STV0 and STV1 are the two IF demodulators for the HP and LP streams
respectively.
• Ark1t_Mip: shows MIP modulation parameters.
• Ark1t_SettingsDvb: shows and sets local modulation parameters.
• Ark1t_Output: shows and manages the output.
• Ark1t_HW_monitor: shows the amplifier status.
• Ark1t_Gps: shows the collection of live data from GPS receiver.
• Ark1t_Clock: shows and sets 10MHz and 1PPS source.
• Ark1t_Network: shows and sets network parameters.
• Ark1t_Alarm: shows and manages system alarms.
• Ark1t_Config: allows the management of the machine configuration.
• Ark1t_TrapAlarm: is the OID used in the trap message: