User`s manual

Chapter 9 - SETUP PART 7: Print Head Alignments - BLAZER PRO
79
Version 5.5 Revised December, 2008
example, the cyan set may be off to the right (enter 9s) and the
magenta off to the left (enter 1s), while the yellow may be
perfect (enter 5s). Completing the “estimation” process too
many times can “over shoot” the alignment causing it to be
off the opposite way. If the pattern is only slightly off (half
of what you see in this example) only two entries may be
necessary.
Continue on to • Step 5 - Final Printout and Calibration.
5. Final Printout and Calibration
At this point you should have made all of your entries in the LFP Remote Panel and Saved. If you exit this
screen without saving your data, it will be lost. If this should occur, return to the correct alignment screen,
re-enter your numbers and select Save.
Turn off your Blazer PRO and Power Back on.1.
After completing and saving your settings in the LFP Remote panel, you MUST turn OFF the printer.
You CANNOT print or perform any additional maintenance routines on your machine without
powering OFF rst. You can do this by simply turning OFF the power using the User Interface OFF
button.
Go back to Step 2 - Printer Setup 2.
In order to get the nal results of your previous calibrations, a new Alignment Pattern Print must be
completed again (as we showed you in Step 3 - Conclusion. You will have to re-set up the lm or
media and go through the entire process again. If you completed the previous steps correctly, your
second printout should be good enough to enter the values, click save and be done with the alignment
process.
NOTE: You can leave the LFP Remote Panel Open until the entire Alignment Process is complete.
For your convenience, a copy of the Print Head Calibration Worksheet has been provided for you on the
next page. Please make copies and save original as a master copy.
Figure 6: Bi-Directional Worksheet-Part 2