User`s manual
Chapter 9 - SETUP PART 7: Print Head Alignments - BLAZER PRO
72
T-Jet Blazer Series User’s Manual
Double check that your lm (or media) is still setup correctly. Also verify that the printer is still in 7.
Index Position and in READY/ROLL Mode.
8. Press the Print button on the LFP Remote Panel Screen.
The print process will take approximately 10 minutes.
After the print is complete, be careful not to smudge the ink, it will be wet for a short while
(depending on what media type you are printing on).
Continue on with the next step. 9.
4. Selection and Entry of the Values
This portion of the Alignment process will be the most difcult. Determining and entering the correct
values may be a bit confusing, but we have gone through great lengths to provide you with the best
possible instructions that will help you understand the process and save you time and money, as well as
getting the best possible print out of your new investment.
1. Study the alignment patterns.
Uni-Directional Alignment Pattern:
If completing a Uni-Directional Alignment, you will notice a group of dotted lines marked either #1, #2 or
#3, representing the Dot Size # your are reviewing.
Each ink color (C, M, Y, Pk/Mk. Lc, Lm, Lk, LLk) will
have it’s own set of lines, numbered 1-9 like the sample
shown here.
NOTE: The Lc, Lm, Lk and LLk represent the 4 white ink
cartridges.
Bi-Directional Alignment Patterns:
If performing a Bi-Directional Alignment, you will see lines for black and individual sets of color
swatches for the colors.
The black and light black ink colors (Pk/Mk and LK) will have it’s
own set of lines like the sample shown here.
The colors (C,M and Y) will each have color swatch set
numbered 1-9 (cyan shown in this example).