User`s manual

Chapter 9 - SETUP PART 7: Print Head Alignments - BLAZER PRO
69
Version 5.5 Revised December, 2008
Align the media with the upper left hand corner of the Shirt Board (the bottom right hand corner if
facing the front of the printer). Over hang the lm 1/2” over the right edge of the Shirt Board.
Measure from the end of the platen (where the metal
platen handle is attached), 15.5”. This is where the rst
sheet needs to be placed. The second sheet will be at
27.5” and the third at 38.5”.
On the UI, browse to the MMMU screen. Under the heading 7. Position, press the Index Button. With
the printer in the Index Position, the Shirt Board(s) is now directly beneath the Printer Assembly.
8. Next, go back to the LCD Display Control Panel and change the printer
mode to “Ready/Roll” mode by pressing the LEFT ARROW button
twice. The display will read “READY” with a “roll of paper” icon.
Continue on with next section.
Continue on with next step. 9.
3. Send the Alignment Test Print
The following steps will cover sending the Print Head Alignment Test Print to the Blazer EXPRESS
through the Epson LFP Remote Panel.
1. Open the LFP Remote Panel by double-clicking on the Epson LFP
icon on your Desktop.
If not present, using your Start menu, select Programs > Epson > Epson LFP Remote
Panel.
15.5” 27.5” 38 1/2”
READY
1