User`s manual

Chapter 9 - SETUP PART 7: Print Head Alignments - BLAZER PRO
67
Version 5.5 Revised December, 2008
BLAZER PRO ALIGNMENTS
This section will cover the execution of
Uni-Directional and Bi-Directional Print
Head Alignments for the Blazer PRO. For
steps on completing these alignments for
the Blazer EXPRESS, refer to the earlier
section of this chapter named Blazer
EXPRESS Alignments.
1. Install the LFP Remote Panel
The alignment procedure is completed by using the Epson LFP Remote Panel. The LFP Remote Panel is
a stand alone application designed to give you several utility functions, including the Nozzle Check and
Power Cleaning utilities, right from your computer. The LFP Remote Panel is included with the Epson
Stylus Pro Driver CD that came with your Blazer Series printer.
Download On Web
The LFP Remote Panel is also available to download from Epson’s website: www.epson.com. Select
Drivers & Support, then select the applicable version for the Stylus Pro based on the Operating System
(Windows XP, Vista, 2000 or MAC).
To determine which Epson Print Engine your printer is equipped with, locate the printer serial number and
compare it to the following table.
If your Serial Number contains the following as the 4th and 5th
digits after TJB. Download the latest LFP Remote Panel for your
particular model.
2. Printer Setup
To continue the Print Head Alignment procedure, you must have the Epson LFP Remote Panel installed
and the computer connected to the printer. The printer must be in “Ready/ROLL” mode and be in the
Index Position with the lm or other media (to print on) in place. If the printer is not in the correct mode,
you will receive a “Communication Failed” error. You will also need to determine the Print Head height
that you will use permanently while printing.
Power up the printer (if not powered up already).1.
BO: EPSON Stylus Pro 4800
BX: EPSON Stylus Pro 4800
B8: EPSON Stylus Pro 4880
BY: EPSON Stylus Pro 4880