User`s manual

Chapter 9 - SETUP PART 7: Print Head Alignments - BLAZER EXPRESS
65
Version 5.5 Revised December, 2008
5. Final Printout and Calibration
At this point you should have made all of your entries in the LFP Remote Panel and Saved. If you exit this
screen without saving your data, it will be lost. If this should occur, return to the correct alignment screen,
re-enter your numbers and select Save.
Turn off your Blazer Express and Power Back on.1.
After completing and saving your settings in the LFP Remote panel, you MUST turn OFF the printer.
You CANNOT print or perform any additional maintenance routines on your machine without
powering OFF rst. You can do this by simply turning OFF the power using the User Interface OFF
button.
Go back to Step 2 - Printer Setup 2.
In order to get the nal results of your previous calibrations, a new Alignment Pattern Print must be
completed again. You will have to re-set up the lm, and go through the entire process again. If you
completed the previous steps correctly, your nal printout should be good enough to enter the values,
click save and continue with the next step - Step 5 - Repeat for Dot Size # 2.
NOTE: You can leave the LFP Remote Panel Open until the entire Alignment Process is complete.
Once you have entered in the correct values, Dot Size #1 is complete.3.
6. Restart for Next Dot Size
You must now restart the printer and setup the printer for Dot Size #2 in the LFP Remote Panel Screen.
Go back to the previous section, Step 2 - Printer Setup and repeat the entire process.
YOU MUST COMPLETE THE ENITIRE PROCESS FOR ALL THREE DOT SIZES TO
ENSURE ACCURATE PRINT OUTPUT.
NOTE: There is a good chance that Dot Sizes #2 and #3 are much closer to alignment than Dot Size #1.