User`s manual
Chapter 9 - SETUP PART 7: Print Head Alignments - BLAZER EXPRESS
58
T-Jet Blazer Series User’s Manual
Select Other for Media Type•
Enter 2 for Paper Thickness•
Select Standard from the Platen Gap drop-down menu. •
WARNING: It is EXTREMELY crucial that you only select ONE Dot Size per
printout! The Blazer EXPRESS does not have enough bed length to print out all
dot sizes in one run. If you do not deselect the other two check boxes, the printer
will error out. If this happens refer to the Error codes in Chapter 15 -
Troubleshooting.
Double check that your lm (or media) is still setup correctly. Also verify that the printer is still in 7.
Index Position and in READY/ROLL Mode.
8. Press the Print button on the LFP Remote Panel Screen.
The print process will take approximately 10 minutes. After the print is complete, be careful not to
smudge the ink, it will be wet for a short while (depending on what media type you are printing on).
Continue on with the next step. 9.
4. Selection and Entry of the Values
This portion of the Alignment process will be the most difcult. Determining and entering the correct
values may be a bit confusing, but we have gone through great lengths to provide you with the best
possible instructions that will help you understand the process and save you time and money, as well as
getting the best possible print out of your new investment.
1. Study the alignment patterns.
Uni-Directional Alignment Pattern:
If completing a Uni-Directional Alignment, you will notice a group of dotted lines marked either #1, #2 or
#3, representing the Dot Size # your are reviewing.
Each ink color (C, M, Y, Pk/Mk. Lc, Lm, Lk, LLk) will
have it’s own set of lines, numbered 1-9 like the sample
shown here.
NOTE: The Lc, Lm, Lk and LLk represent the 4 white ink
cartridges.