User`s manual
Chapter 9 - SETUP PART 7: Print Head Alignments - BLAZER EXPRESS
55
Version 5.5 Revised December, 2008
test pattern on, before adjusting the distance setting. A DISTANCE OF 3 MM IS REQUIRED.
This step is important in the process, because the distance between the Print Head and the “Media”
used during the alignment process will need to be the exact distance between the Print Head and the
garment that you will later print on. 3mm is the ideal setting and will give you the most crisp prints.
If this is not recorded and adjusted correctly, your alignment process will not be as accurate for later
printing.
3. Set the printer from Print to “Ready/Sheet” status by pressing the
LEFT/PAPER button twice on the LCD Control Panel. The display
will read “Ready” and display a “sheet of paper” icon. Only when in
“Ready/Sheet” status can the Printer Assembly be moved freely.
4. Using the “RIGHT hand” button, shufe through the UI screens
until you get to the Mode Select screen. Conrm that the mode is set to Manual.
Press the “RIGHT hand” button on the UI again until you reach 5.
the Manual Mechanism Movement Utility (MMMU) screen.
6. Prepare the media printing on, to cover an area of 16” x 20”
(41 cm x 53 cm) The Blazer EXPRESS can only perform one
“Dot Size” at a time. A single Head Alignment procedure consists
of 3 “Dot Sizes”. You will need to reload the media a total of three
times per alignment.
Align the media with the upper left hand corner of the Oversized
Shirt Board (the bottom right hand corner if facing the front of the
printer). Over hang the lm 1 inch over the edge of the Shirt
Board.
On the UI, browse to the MMMU screen. Under the heading Position, press the Index button. With 7.
the Printer in the Index position, the Shirt Board is now directly beneath the Printer Assembly.
8. Next, go back to the LCD and change the printer mode to “Ready/Roll”
mode by pressing the LEFT ARROW button twice. The display will
read “READY” with a “roll of paper” icon.
Continue on with next step.9.
READY
1
READY
1