User`s manual

Chapter 7 - SETUP PART 5: Learning the LCD and User Interface Controls
30
T-Jet Blazer Series User’s Manual
Pause Button
Pressing the Pause Button will pause a print job while printing. Holding down the Pause Button for 3
seconds will cancel a print job.
Left/Paper Button
This button is used to navigate throughout the LCD screens. It is also used to adjust the “paper”
setting of the printer.
Down Button
This button is used to navigate through the LCD screens.
Up Button
This button is used to navigate through the LCD screens.
Right/ Clean Button
This button is used to navigate through the LCD screens. It is also used to perform a Head Cleaning
Utility by holding down for 3 seconds; see Chapter 8 - SETUP PART 6 - Initialization Utilities.
The LCD Display Icons
As mentioned earlier, the icons listed below will mean a different printer function and will be covered in
detail in another chapter.
Sheet Icon
The Sheet icon is referred to as Sheet Mode preceded by any phrase above it such as
“Ready/Sheet” mode or “Paper Out /Sheet” mode.
Roll Icon
The Roll icon is referred to as Roll Mode preceded by any phrase above it such as
“Ready/Roll” mode or “Paper Out /Roll” mode.
Roll Scissors Icon
The Roll & Scissors icon is referred to as Roll Cut Mode preceded by any phrase above
it such as “Ready/Roll Cut” mode or “Paper Out /Roll Cut” mode.
WARNING
DO NOT press or attempt to use any button on the Epson LCD Display not
covered in this Manual. Failure to follow this guideline can result in extended
downtime, ruined output and/or damage to your printer that is not covered
by warranty. If you note erratic machine behavior when attempting to print,
immediately shut down the printer and contact Technical Support.