User`s manual

Chapter 11 - Printing Basics
111
Version 5.5 Revised January, 2009
Eight Color Print Modes
The Fast T-Jet Blazer Express also supports Eight Color Print Modes that utilize the additional colors
of Red, Green, Blue and Orange in place of the four White cartridges. This conguration of inks cannot
be used to print on dark garments, however when printed on light garments, the additional colors create
vibrant hues that add an exciting dimensionality to your nal output.
IMPORTANT POINT
The Eight Color Bulk Ink System is an optional conguration. If your printer is not
equipped with the necessary inks and cartridges, you may purchase the additional
accessories from U.S. Screen Print & Inkjet Technology. Refer to Chapter 7 of your
FastARTIST User’s Manual for details on ink cartridge placement.
Underbase Print Modes
The Underbase Print Modes may only be selected from within FastARTIST. With Cartoon and Photo
Print Modes available in three different resolutions as well as having a High Speed opotion, you have
the ability to select the proper mode to match your graphic image. For dark shirts try using the 1440 HS
(High Speed) Print Mode to achieve a stronger, more consistent Underbase. This is due to the fact that
the higher resolution will dispense more ink at a slower speed, creating extremely even coverage, plus
the High Speed options will also cut the printing time down considerably. If you are printing on lighter
colored shirts, it may not be necessary to print such a strong Underbase. 720 DPI may work better.
See the previous section for more information on High Speed Printing. For a complete list of the
various CMYK, Eight Color and Underbase Print Modes available, refer to Chapter 7 of your
FastARTIST User’s Manual.
Printing Concerns
Spots or Stains
Spots or ink stains must be removed BEFORE
the print is cured, using a standard Spot Removal gun. Once
the ink is cured, it is almost impossible to remove spots or
smudges. Take care NOT to spray the wet print!
Washability Related Concerns
Turn print inside out before washing or drying. Use cold
Water only with a medium dryer temperature. If possible, give the customer washing instructions with
the nished prints. You can expect a little fading with the rst washing. This is normal and very similar
to what you would get from a screen printed shirt. If you experience irregular fading, check your dryer
temperature. If the shirts are damp from excess humidity, you should put them under the Heat Press for a
few seconds to dry out before printing (see the following humidity section).
If you have any washability issues increase the time.