User`s manual

If, AT ANY TIME, you have performed three Nozzle Checks without
rebooting your printer, you must power OFF your printer before
executing another one.
Once you have obtained a satisfactory Nozzle Check press the Power OFF
button on the UI. After the printer has completed its shutdown process, Power
ON at the UI and perform a Print Head Alignment.
Print Head Alignment
In addition to the initial setup requirements, it may be necessary to perform a
Print Head Alignment on other occasions such as:
If the Print Head makes contact with • any object- whether it’s a garment or a
Shirtboard
If your prints contain vertical lines or misaligned parts of an image•
If you see banding of any kind•
Please be aware, should the Print Head make contact with ANY solid surface, it
may be permanently damaged and require replacement.
Whether you are performing the Initial Setup, or correcting minor printing
concerns, the following steps are necessary to perform a Print Head alignment
for your Fast T-Jet Blazer.
Performing a Head Alignment on a Fast T-Jet Blazer will require
approximately 20-30 minutes. Before beginning this procedure
ensure you are familiar with all the required steps, as well as having
the necessary time to complete the process. Once you have
begun a Head Alignment you CANNOT exit the function without
shutting down the machine. In addition, early exit may result in
severe misalignment of the Print Head or other operational
concerns. Initial setup may require 2-3 alignment procedures to be
completed.
You CANNOT skip this process during setup or your prints may
suffer. Performing a precise and COMPLETE Head Alignment is
extremely crucial to creating great images with your Fast T-Jet
Blazer.
15
Utilities to Improve Print Quality