User`s manual

After removing the four screws, gently slide the metal cowling free and the
Waste Tank will be easily accessible. To remove the Waste Tank, slide if from its
bin. To replace the Waste Tank after maintenance, slide it back into place and
reattach the metal enclosure.
Perform a Nozzle Check
A Nozzle Check is used to ensure the Print Head is performing properly. You may
use either paper or lm for this test, but we recommend lm such as FastPOSITIVE,
available from U.S. Screen. Otherwise it’s difcult to see White ink on White
paper. To initiate a Nozzle Check:
Take the printer from 1. Print to “Ready (Sheet)” status by pressing the LEFT
arrow button twice. The LCD display will read “Ready” and you will see a
“sheet of paper” icon. Only when in “Ready (Sheet)” status can the Printer
Assembly be moved.
Using the “RIGHT hand” button, shufe through the UI screens until you get to 2.
the Mode Select screen. Ensure the virtual dial is set to Manual.
Press the “RIGHT hand” button on the UI again until you reach the 3. Manual
Mechanism Movement Utility (MMMU) screen.
Place your sheet of lm or paper on the 4. rst Shirtboard. The rst position is
furthest from the UI and power cables. Take care to align the lm or paper
with the Shirtboard’s lower right hand corner (as you face the front of the
printer.)
Under the heading 5. Position, press the Index button. This will advance the
Printer Assembly to the beginning of the Platen. Using the Rev button, position
the Printer Assembly over the medium onto which you will print.
You must now change the printer mode to “Ready (Roll).” Press the LEFT 6.
arrow button on the LCD Control Panel twice. The display will read “Ready”
with a “roll of paper” icon.
On Control Panel, press the RIGHT arrow once and the display will read 7.
“Printer Setup.” Press the DOWN arrow once to see “Test Print.”
Press the RIGHT arrow button once to see “Nozzle Check.” Press the RIGHT 8.
arrow again and “Print” will appear in the display.
To execute the Nozzle Check, press the RIGHT arrow button once.9.
If the Nozzle Check does not print correctly, perform a regular Head Cleaning.
This is done by holding down the RIGHT arrow button for 3 seconds. After the
Head Cleaning has been completed, execute another Nozzle Check.
14
Fast T-Jet Blazer Maintenance Manual