User`s manual

A typical print problem that can occur is when lines are missing in the nal
image. This is called banding and it can happen for a variety of reasons. The
most common reasons for banding are a dirty or clogged Print Head, or one
that is misaligned.
If your prints are unexpectedly light, or dots or lines are missing, you may need to
clean the Print Head. If you allow one of the ink bottles on the bulk ink system to
run dry or if your printer has been sitting for a few days without use, you will need
to clean the Print Head.
U.S. Screen is not liable for any damage caused by ink to property
such as carpets, ooring or furniture . Please read and understand
all operating and maintenance procedures before using the Fast
T-Jet Blazer.
Head Cleanings
Turn the printer ON by setting the breaker switch to the UP position. Wait ve
seconds for the Red indicator light and then press the Orange Power button on
the UI.
There are two types of Head Cleanings available for use on the Fast T-Jet
Blazer- a regular cleaning and a Power Cleaning. Both unclog the Nozzles so
they can deliver ink properly. However, depending upon the severity of your
problem, your only option may be the Power Cleaning. Be advised, a Power
Cleaning will consume a lot of ink.
To prevent having to do Power Cleanings, we recommend initiating at least
one regular head cleaning cycle each day. A Regular Head Cleaning cycle
will also use a fair amount of ink, but not nearly as much as a Power Cleaning.
Power Cleaning
Power Cleanings are executed from the LCD Control Panel with the virtual dial in
Manual on the Mode Select Screen of the UI:
11
Fast T-Jet Blazer
Utilities to Improve Print Quality