User`s manual

Fast T-Jet Blazer Pro User’s Manual

FastARTIST refers to its page dimensions in terms of width and

“height.” For purposes of printing a two-dimensional image on a

garment or non-textile item, it is important to be aware of the fact

that “height” means the same thing as “length.”

FastARTIST Page Size – Go to Layout > Page Size

FastRIP Setup – Go to File > FastRIP Setup

For more information about printing on caps or Non-Textile, such as golf balls,

there is a downloadable PDF available at www.screenprinters.net.

Adjusting the Platen Height

For the best prints, the printable surface should set to 1/8inch (3mm) below the

Print Head. If the item has a seam or excess fabric, these areas should be lower

than the main printing surface.

Ensure the garment or non-textile item does not sit closer to the

print head than the preferred of 1/8inch (3mm).