User`s manual

friend. It can settle on key components inside

the Fast T-Jet Blazer Pro, affecting print quality

and printer operation. For better results, grab a

shirt by the shoulder seams and snap it like you

would a small dusty rug before you place it on

the Shirtboard. This will actually help pull out

wrinkles as well. For the best results, use a Heat

Presstoheatandattenthegarmentand

bersbeforeloading.

LaythegarmentontheShirtboard,stufngany•

excess into the space between the top and

base.

DO NOT leave a collar or seams exposed on top of the Shirtboard. The •

Print Head may strike this when printing. Load the collar over the so its out

oftheway.Itisalsocriticalthattheshirtlayat.Anyuctuationsinthe

printing surface could cause the print to be soft or out of register.

Return the Platen to its operating position by pushing it back toward the 4.

printer until its ends are even with the ends of the Bed Rail.

Choose the artwork you wish to print. 5.

You can print directly to FastRIP from your

favorite graphics application (if you are not

outputting an Underbase or Highlight White),

or you can print from within FastARTIST.

Ensure the image is the correct size and that

you have placed it in on a “Page” that is the

same size as the printable area.

The easiest way to get the correct

print placement is create a template for the size and placement of the

Shirtboards or use FastARTIST and load a pre-made Template. (Remember,

you MUST use FastARTIST if you will be printing with White ink. Refer to Chapter

7 of this Manual and Chapter 9 of your FastARTIST Manual for more details.)

The Blazer Pro will support a total printable area of 17” x 45” (43 cm x 114

cm). If you are using an application other than FastARTIST, you must create a

Custom Page Size to represent this and the positions of the Shirtboards.

Chapter 6- Printing with the Fast T-Jet Blazer

Pro