User`s manual

If you are performing this procedure as part of your printer’s Initial

Setup or if you notice a severe registration issue, we recommend

you perform the Uni-Directional Alignment rst, followed by a Bi-

Directional Alignment. If you only wish to ne tune printer output,

you can utilize the Bi-Directional Alignment as a standalone

procedure.

Within the Bi-Directional or Uni-Directional Alignment screens, place a 2)

check mark in each of the three boxes below Dot Size. Select Other for

Media Type, enter 2 for Paper Thickness and select Standard from the

Platen Gap dropdown menu.

DO NOT modify any of the numbers in the boxes at this time.

Prepare1-2sheetsoflmtocoveranarea16”x24”(41cmx61cm)3)

in size. You may also use paper to print the Head Alignment images,

howeveritwillbeverydifculttoseeWhiteinkonWhitepaper.Alignyour

paper or other media with the upper left hand corner of Shirtboard #1.

With the Printer in the Index position, Shirtboard #1 is the Shirtboard that is

now directly beneath the Assembly.

Press 4) Print.

Refer to Step #17 (page 28-29) for images and a description of the

resulting output and how to select the corresponding entry.

Once the printer has completed the test patterns, instead of entering the 5)

numbers through the LCD Display, enter the best results information in the

corresponding boxes on the Alignment Screen.

Click on 6) Save to record your calibrations. If you exit this screen without

saving your inputs, they will be lost. If this should occur, return to the

Fast T-Jet Blazer Pro User’s Manual