User`s manual

Chapter 4

Initialization Utilities

U.S. Screen is not liable for any damage caused by ink to property

such as carpets, ooring or furniture . Please read and understand

all operating and maintenance procedures before using the Fast

T-Jet Blazer Pro.

You have the Bulk Ink System in place and the Printer Driver installed, but there

is one more step to take before you can start printing; you must perform an

initializationprocessthatwillgettheinkowing,setthePlatentothecorrect

height for printing and ensure the Print Head Nozzles are in proper alignment to

output the best possible images.

To begin the initialization, turn the printer ON by setting the breaker switch to

theUPposition.WaitvesecondsfortheRed indicator light and then press the

Orange Power button on the UI.

Head Cleanings

There are two types of Head Cleanings available for use on the Fast T-Jet

Blazer Pro- a regular cleaning and a Power Cleaning. Both unclog the Nozzles

so they can deliver ink properly. However, depending upon the severity of your

problem, your only option may be the Power Cleaning. Be advised, a Power

Cleaning will consume a lot of ink.

To prevent having to do Power Cleanings, we recommend initiating at least

one regular head cleaning cycle each day. A Regular Head Cleaning cycle

will also use a fair amount of ink, but not nearly as much as a Power Cleaning.

Power Cleaning

You mustperformaPowerCleaningduringsetuptoensureinkisproperowing

through the ink lines. You will need to execute approximately three Power

Cleanings to initialize your printer.

Power Cleanings are executed from the LCD Control Panel with the virtual dial in

Manual on the Mode Select Screen of the UI:

Place the printer in 1. Print status. This is done by lifting the printer cover and

locating the LCD Control Panel above the White ink cartridges. Press the LEFT