User`s manual

Fast T-Jet Blazer Pro User’s Manual
18
The Roll & Scissors icon is referred to as Roll Cut Mode preceded
by any phrase above it such as “Ready (Roll Cut)” mode or
“Paper Out (Roll Cut)” mode.
The User Interface
TheFastT-JetBlazerProistherstT-JetseriesInkjet-to-Garmentprinterto
incorporate a User Interface (UI) into its design. The UI adds convenience and
function, allowing you to perform several operations from its screens rather than
at the printer itself. Each screen is touch sensitive, allowing you to navigate
betweenscreensorchangescreensettingswithatouchofyournger.
There are currently 5 UI screens.
The Mode Select Screen
The Mode Select Screen allows you
to choose from two modes- Manual
which would be used when running any
Maintenance Utilities and Auto which
enables you to choose the number of Print
Passes for your garments as well as send a
Print command from FastARTIST for image
output.
To change from Manual mode to Auto
mode or vice versa, touch the virtual dial
once.
You must be in Manual mode to utilize any functions on the UI or
perform any Maintenance Utilities such as Head Cleanings, Head
Alignments, etc. To Print, you must be in Auto mode.
The Manual Mechanism Movement Utility (MMMU) Screen
The MMMU Screen controls the movement of the Printer Assembly prior to and
after completion of a printing job.
The Assembly has three preset positions and these are listed under the heading
“Position”: Home, Nest and Index.
Pressing and holding the Home button for 2 seconds will move the Printer
Assembly to the end of the Platen and this is the position from which you will