User`s manual

the heat source.

At night, and when the printer is not in use, cover the

machine to protect it from airborne dust and debris.

Important Point

When using White ink, you must apply a Pretreatment

to the shirts before printing. DO NOT spray this

Pretreatment near your Fast T-Jet Blazer Pro.

Pretreat shirts in a different room, if possible but at

a minimum, make a cardboard enclosure for use

during applications. The Pretreatment is sticky and

can ruin the Print Head as well as damage the

Encoder Strip. The Encoder Strip is a thin piece of

clear plastic with data that is read by the Print Head

as the unit operates. The Encoder Strip tells the Print

Head exactly where to print an image. If the Encoder

Strip becomes dirty or damaged, the printer will get

confused, resulting in the printing of multiple images,

strips of solid ink and other irregular printing patterns.

Final Unpacking Instructions

Removethepackingtapethatwasusedtosecurethelowproleaccesslid

and raise the cover.

DO NOT try to move the Print Carriage off of the Capping Station. The Fast T-Jet

Blazer Pro locks the Print Carriage onto the Capping Station and forcing the Print

Carriage to move will damage your printer.

Note:YoumayndasmallamountofinkontheWastePadand/orCapping

Station during setup. This is normal and there is no need to be alarmed. Each

printer is run through a series of print cycles before shipping to ensure it is

operating properly.

Chapter 2- Unpacking and Setup