User`s manual

Print drivers may need to be re-installed•
Print drivers are prone to occasionally stop communicating with the Windows
XP operating system. The only solution is to re-install the driver.
Too many items may be connected to your USB port•
If you have any additional items connected to your USB ports, unplug
everything but the mouse and the Fast T-Jet Blazer Pro. The USB bus on your
computer only has only a limited amount of power.
The image le may be corrupt•
Thelebeingprintedmaybecorrupt.Tryanotherle.
USB cable may be too long•
Your USB cable should not be MORE than six feet in length.
Prevention:
Keep it simple. Do not overload the printer port.•
Whenindoubtrsttryturningeverythingoffandunpluggingthingssuchas•
the USB cable from the computer to the printer.
Problem:
When printing White ink, no ink prints or there are no Underbase settings
available.
Causes and Solutions:
You do not have the correct printer selected in FastRIP.
Open FastRIP and navigate to Printers/Manage Printers and make sure your
printer is setup as a Fast T-Jet Blazer Pro. If it is NOT setup as a Blazer Pro, FastRIP
doesn’t know that it needs to use the White ink.
Problem:
When you send a print job to the printer nothing happens.
Cause:
The computer is not communicating with the printer.•
Check the port settings in FastRIP. In the FastRIP window go to Printers/
Manage Printers. The port should be set to Epson stylus pro 4800_usb00*.
Check the Control Panel box on the right. Make sure there are no other jobs
already in the print queue.
The printer is not ready to print the job.•
Check to see if any of the ink cartridges are showing empty.o
The Waste Tank may be full. Check the LCD Display.o
You many not be in o Print status (Refer to Chapter 4)
100
Fast T-Jet Blazer Pro User’s Manual