User`s manual

Fast T-Jet Blazer Pro User’s Manual
96
Problem:
The Print Head is leaking, dripping ink on garments.
Causes:
The Print Head may have been damaged by a collision•
Order a replacement Print Head.
The Print Head is saturated with ink•
Thoroughly clean the Capping Station. The Capping Station can
becomedirtywithgarmentlintorbersaswellasdriedink.Thiswill
prevent it from adequately cleaning the Print Head.
Debris or shirt bers have collected on the Print Head as well as the Print Head •
Carriage
Gently clean the bottom of the Print Head to remove any debris, dried ink
andbers.AlsochecktheCappingStationtoensureitiscleanandfreeof
debris and lint.
Too much ink is coming through the Print Head•
IfyoulledtheBulkInkCartridgespasttheFull Line there could be too much
pressure in the bulk system ink lines, forcing ink out of the Print Head.
Altitude can have an effect•
The bulk ink system requires the proper vacuum pressure to siphon the ink into
the Print Head. If you are having an unusual amount of problems and are at
ahigheraltitude,don’tlltheinkbottlesasfull.
Faulty bulk system•
Call Technical Support.
Prevention:
Always check the Platen to Print Head Clearance prior to printing.•
Clean the Capping Station on a regular basis.•
Clean debris from the Print Head daily.•
DonotoverlltheBulkInkCartridges.•
Problem:
The printed image is wiping off, washing out, fading badly or bleeding.
Causes:
The garment was improperly cured •
Garment ink requires a temperature of 330 degrees F. to cure properly. Apply
this heat for at least 60-90 seconds for Light garments and for at least 180-240
seconds for Dark garments
Too much or too little pressure was applied when Heat Pressing •
When pressing the garment, the Heat Press should rest on the silicone or