User`s manual

Chapter 8 - Initialization Utilities
67
Nozzle Check and Power Cleaning
Utilities from the LFP Remote Panel
To execute a Nozzle Check test print or a Power Cleaning from the LFP Remote Panel, refer to the
previous section - About the LFP Remote Panel and Installation for installation procedures.
Select Power Cleaning from the LFP
1.
Remote Panel Main Screen.
Within the next screen, select your
2.
printer from the drop-down menu
and click on the desired function.
When the procedure is complete,
3.
click Exit.
If the Nozzle Check does not print
correctly, perform a regular Head
Cleaning. See Performing a Head
Cleaning earlier in this chapter.
IMPORTANT NOTE:
If, AT ANY TIME, you have performed three consecutive Nozzle Checks without
rebooting your printer, you must power OFF your printer before executing another
one.
Once you have obtained a satisfactory Nozzle Check, press the Power button on the UI to turn OFF
4.
your printer. After the shutdown process has been completed, turn the power back ON and you may
resume normal operations. To begin the Head Alignment process, place your printer in “Paper Out
(Roll/Cut)” mode. The LCD Display will read “Paper Out” and display the “roll” icon in addition to
the “scissors” icon.