User`s manual
T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
66
An important factor is determining how far the particular gap is in the pattern. This
gure will determine your next print outcome. If the pattern is spaced apart
tremendously, (like the previous examples) the alignment may require 4 adjustments
before printing the next test pattern, however, if the alignment is close, it may only
require 2 entries. It may be difcult determining how many times you will need to
do this, which is why the process is most successful for initial setup. Travel of the
printer usually requires 2-3 alignment process while other needs of an alignment
may require only one.
Enter in the chosen number (9) on all values where the default of 5 is entered.
3.
4. Next, click the Save button and click OK. The screen will go back to the
default Alignment screen where all of the boxes have 5 entered.
Repeat of the entries (of 9) twice for a total of 3 complete entries (recommended for initial setup).
5.
NOTE: for other situations or if the rst printout is fairly close, you may only have to repeat once.
Reprint the Print Alignment. This means basically starting the entire process over LFP Alignment
6.
process over for the nal calibration or test. NOTE: the printout should be MUCH closer in alignment
if not perfect.
Enter in your new calculations (the correct or best selection of each color etc.).
7.
Save your entered data.8.
Click the Save button to record your calibrations. If you exit this screen without saving your data, it
will be lost. If this should occur, return to the correct alignment screen, re-enter your numbers and
select Save. The Quick Alignment process is now complete.
IMPORTANT POINT: After completing and saving your settings in the LFP
Remote panel, you MUST turn OFF the printer. You CANNOT print or perform
any additional maintenance routines on your machine without powering OFF rst.
You can do this by simply turning OFF the power using the User Interface OFF
button.