User`s manual
Chapter 8 - Initialization Utilities
63
Press the Down ARROW Button ve times. The LCD Display will read, “2. Head Alignment.”
Press the Right ARROW/Enter Button once and the LCD will display, “
3. Paper Thkns.”
Press the
4. Down ARROW once to “Alignment.”
Press the Right ARROW/Enter Button once to see “Alignment Auto.”
5.
Press the 6. Down ARROW to see “Alignment Manual.”
Press the Right ARROW/Enter Button once and the LCD will display, “Alignment Manual Uni-D.”
7.
Press the 8. Down ARROW to select “Alignment Manual Bi-D All.”
Press the Right ARROW/Enter Button to begin printing.
9.
The print process will take approximately 10 minutes. After the print is complete, be careful not to
smudge the ink, it will be wet for a short while.
Selection and Entry of the Values
1. Study the alignment patterns.
If completing a Uni-Directional Alignment, you will notice two columns and a group of dotted lines
marked #1, #2 and #3, representing each Dot Size. NOTE: The Express will only print 1 at a time. If
performing a Bi-Directional Alignment, you will also see individual sets of color swatches. These
particular groups will consist of:
Each alignment will be identied by a number (#1, #2, #3) that represents the dot size pattern on the
alignment. NOTE: The Blazer EXPRESS needs to print out Dot Sizes #2 and #3 separately.There will
also be a color designation (C, M, Y, Pk/Mk. Lc, Lm, Lk, LLk) for each. You will notice that there are
two columns of identical groups. The rst, or left hand column, will be used for calibration. The second
column is only a duplicate image of the rst column.
9 sets of vertical, dotted
line patterns numbered 1-9,
representing each ink color.
9 color swatch sets for each of
the three colors labeled C, M
and Y numbered 1-9.
9 color swatch sets for each
of the four white cartridges
labeled Lk, Lc, Lm and LLk
numbered 1-9.