User`s manual

T-Jet Blazer Series User’s Manual

Version 5.0 Revised September, 2008

as it will need to be for Bi-Directional Printing (High Speed). NOTE: Make sure that all of the Shirt

Boards have been leveled properly. Refer to the earlier section, Shirt Board Height Settings for the

Blazer PRO.

2. Set the printer from Print to “Ready/Sheet” status by pressing the

LEFT ARROW button twice on the LCD Control Panel. The display

will read “Ready” and you will see a “sheet of paper” icon. Only when

in “Ready/Sheet” status can the Printer Assembly be moved freely.

3. Using the “RIGHT hand” button, shufe through the UI screens

until you get to the Mode Select screen. Conrm that the mode is set to Manual.

Press the “RIGHT hand” button on the UI again until you reach

the Manual Mechanism Movement Utility (MMMU) screen.

5. Prepare the media printing on, to cover an area of approximately

17” x 44”(43 cm x 112 cm). The Blazer PRO can print out all 3

“Dot Sizes” in 1 media layout. The measurement we provided has

come from the layout of four 11 x 17 (tabloid) sheets laied out

horizontally meaning that the layout supports 17” wide by 4-up.

Align the media with the upper left hand corner of the Oversized

Shirt Board (the bottom right hand corner if facing the front of the

printer). Over hang the lm 1 inch over the edge of the Shirt Board. Bud each sheet together leaving

no gaps.

On the UI, browse to the MMMU screen. Under the heading Position, press the Index button. With

the Printer in the Index position, the Shirt Board(s) is now directly beneath the Printer Assembly.

7. Next, go back to the LCD and change the printer mode to “Ready/Roll”

mode by pressing the LEFT ARROW button twice. The display will

read “READY” with a “roll of paper” icon.

Continue to next section.

BLAZER PRO Alignment Procedures - LCD Display

Whether you are performing the Initial Setup or correcting minor printing concerns, the following steps

are necessary to perform a Print Head alignment using the LCD Display Control Panel. You may also

complete the process using the LFP Remote Panel. If completing the Head Alignment process for the

initial setup, also see the later section - Quick Alignment (Optional). You may be able to save time with

this option.

On the printer LCD Display Control Panel, press the RIGHT ARROW/ Enter Button once. The LCD

Display will read, “Printer Setup.”

READY