User`s manual

T-Jet Blazer Series User’s Manual

Version 5.0 Revised September, 2008

NOTE: If all of the swatches look the same see chart below.

Repeat entries for other colors.

Repeat the process of selecting the best line and swatch for each set of colors and lines in the entire

group. In order to complete this stage of the Print Head Alignment process, you must ll in all boxes

with their corresponding number.

Save your entered data.

Click the Save button to record your calibrations. If you exit this screen without saving your data, it

will be lost. If this should occur, return to the correct alignment screen, re-enter your numbers and

select Save.

IMPORTANT POINT: After completing and saving your settings in the LFP

Remote panel, you MUST turn OFF the printer. You CANNOT print or perform

any additional maintenance routines on your machine without powering OFF rst.

You can do this by simply turning OFF the power using the User Interface OFF

button. Power back up and return to the Head Alignment screens to repeat this

process for Dot Sizes 2 and 3. YOU MUST COMPLETE THIS PROCESS FOR

ALL THREE DOTS TO ENSURE ACCURATE PRINT OUTPUT.

You may now continue on with Chapter 9 - Software Overview (for initial setup), continue printing

or perform another Print Head Alignment to check the results of your previous calibrations. Keep in

mind, you may be required to perform several Head Alignment procedures to initially calibrate your

machine for proper image output.

If all of the swatches for a particular color look like above,

select number 1 as the value. By selecting 1, the alignment

will shift the correct way on the next alignment printout (or

entry).

If all of the swatches for a particular color look like above,

select number 9 as the value. By selecting 9, the alignment

will shift the correct way on the next alignment printout (or

entry).