User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
58
In the Auto Adjustment section of the Media Adjustment window, select Bi-Directional or Uni-5.
Directional Alignment from the drop down menu (depending on what alignment you want to
complete). If you want to print in High Speed Print Modes (Bi-Directional), you will want to
complete the Alignment process for both Uni and Bi-Directional. Some of our users have had success
completing only the Bi-Directional Alignment.
NOTE: DO NOT select any of the Auto Alignment options (in blue) on this screen.
IMPORTANT NOTE:
If you are performing this procedure as part of your printer’s Initial Setup or
if you notice a severe registration issue, we recommend you perform the
Uni-Directional Alignment rst, followed by a Bi-Directional Alignment. If you
only wish to ne tune printer output, you can utilize the Bi-Directional
Alignment as a standalone procedure.
6. Within the Bi-Directional or Uni-Directional Alignment screens, place a check mark in the rst of the
three boxes ONLY, below Dot Size. (You will have to repeat this process two ADDITIONAL times,
placing check marks in Dot Size 2 the second time and Dot Size 3 the third time.) Select Other for
Media Type, enter 2 for Paper Thickness and select Standard from the Platen Gap drop-down menu.
Double check that your lm (or media) is still setup correctly. Also verify that the printer is still in
7.
Index Position and in READY/ROLL Mode.
DO NOT modify
any of the numbers
in the boxes yet.