User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
54
• Examine the Lines
The rst set of vertical lines begin with PK/MK, which refers to Black,
numbered 1-9. Carefully examine the printed lines and determine the cleanest,
straightest line. Select this line by entering its number (1-9) in the
corresponding box in the LFP window.
• Examine the swatches (Bi-Directional only)
The “C” refers to the Cyan color swatch. Examine the Cyan
swatches and select the one closest to a perfect rectangle with no
gaps or breaks in color. Enter the best swatch number (1-9) in its
corresponding box on the LFP Remote Panel screen.
NOTE: If all of the swatches look the same see chart below.
Repeat Entries for other colors
3.
Repeat the process of selecting the best line and swatch for each set of colors and lines in the entire
group. In order to complete this stage of the Print Head Alignment process, you must ll in all boxes
with their corresponding number.
Save your entered data.
4.
Click the Save button to record your calibrations. If you exit this screen without saving your data, it
will be lost. If this should occur, return to the correct alignment screen, re-enter your numbers and
select Save.
Restart for next Dot Size.
5.
You must now restart the printer and setup the printer for Dot Size #2 in the LFP Remote Panel
Screen. Go back to the previous section, BLAZER EXPRESS SETUP - Step 2, and repeat the
process.
IMPORTANT POINT: After completing and saving your settings in the LFP
Remote panel, you MUST turn OFF the printer. You CANNOT print or perform
any additional maintenance routines on your machine without powering OFF rst.
You can do this by simply turning OFF the power using the User Interface OFF
button. Power back up and return to the Head Alignment screens to repeat this
process for Dot Sizes 2 and 3. YOU MUST COMPLETE THIS PROCESS FOR
ALL THREE DOTS TO ENSURE ACCURATE PRINT OUTPUT.
After completing the process for all three
6. Dot Sizes, you may continue on to Chapter 9 - Software
Overview (for initial setup), continue printing or perform another Print Head Alignment to check the
results of your previous calibrations. Keep in mind, you may be required to perform several Print
Head Alignment procedures to initially calibrate your machine for proper image output.
GOOD
LINE
BAD
LINE
BEST
SWATCH
WORST
SWATCH
If all of the swatches for a particular color look like above,
select number 1 as the value. By selecting 1, the alignment
will shift the correct way on the next alignment printout (or
entry).
If all of the swatches for a particular color look like above,
select number 9 as the value. By selecting 9, the alignment
will shift the correct way on the next alignment printout (or
entry).