User`s manual

Chapter 8 - Initialization Utilities

WARNING: It is EXTREMELY crucial that you only select ONE Dot Size per

printout! The Blazer EXPRESS does not have enough bed length to print out all

dot sizes in one run. If you do not deselect the other two check boxes, the printer

will error out. If this happens refer to the Error codes in Chapter 15 -

Troubleshooting.

Double check that your lm (or media) is still setup correctly. Also verify that the printer is still in

Index Position and in READY/ROLL Mode.

8. Press the Print button on the LFP Remote Panel Screen.

The print process will take approximately 10 minutes.

After the print is complete, be careful not to smudge the ink, it will be wet for a short while.

Selection and Entry of the Values

1. Study the alignment patterns.

If completing a Uni-Directional Alignment, you will notice two columns and a group of dotted lines

marked #1, #2 and #3, representing each Dot Size. NOTE: The Express will only print 1 at a time. If

performing a Bi-Directional Alignment, you will also see individual sets of color swatches. These

particular groups will consist of:

Each alignment will be identied by a number (#1, #2, #3) that represents the dot size pattern on the

alignment. NOTE: The Blazer EXPRESS needs to print out Dot Sizes #2 and #3 separately.There will

also be a color designation (C, M, Y, Pk/Mk. Lc, Lm, Lk, LLk) for each. You will notice that there are

two columns of identical groups. The rst, or left hand column, will be used for calibration. The second

column is only a duplicate image of the rst column.

Enter “Best” Values

The next step is to enter the best results from the printout in the Alignment Screen and in the

corresponding Dot number (1 being the rst round and 3 being the last).

9 sets of vertical, dotted

line patterns numbered 1-9,

representing each ink color.

9 color swatch sets for each

of the three colors labeled

C, M and Y numbered 1-9.

BI-DIRECTIONAL ONLY

9 color swatch sets for each

of the four white cartridges

labeled Lk, Lc, Lm and LLk

numbered 1-9.

BI-DIRECTIONAL ONLY