User`s manual

T-Jet Blazer Series User’s Manual

Version 5.0 Revised September, 2008

Activate the Nozzle Check Utility

A Nozzle Check Utility can be activated through the LCD Display Control Panel or the LFP Remote

Panel (see later section in this chapter). For steps on activating through the LCD Display Control Panel,

carefully follow the steps below.

1. The printer should now be in READY ROLL Mode. Press the RIGHT

ARROW Button once - the display will read “Printer Setup.”

2. Press the DOWN ARROW Button once to see “Test Print.”

3. Press the RIGHT ARROW Button once to see “Nozzle Check.”

4. Press the RIGHT ARROW Button again and “Print” will appear in the display.

To execute the Nozzle Check, press the RIGHT ARROW button once.

If the Nozzle Check does not print

a “GOOD” pattern, perform a regular Head

Cleaning Cycle.

Head Cleaning Utility

The Head Cleaning Utility is much like a Power Cleaning Cycle but it

consumes much less ink. To perform a Head Cleaning, hold down the RIGHT/

CLEAN ARROW Button on the LCD Display Control Panel for 3 seconds. If

you are performing a Head Cleaning to correct the results of a Nozzle Check,

execute another Nozzle Check to see if the Head Cleaning was successful. If not,

repeat the Head Cleaning/Nozzle Check Utilities.

IMPORTANT NOTE:

If, AT ANY TIME, you have performed three Nozzle Checks without rebooting

your printer, you must power OFF your printer before executing another one. If

completed 4 Head Cleaning Cycles and you are not getting results, a Power Cleaning

Cycle may be required.

PRINTER SETUP

TEST PRINT

NOZZLE CHECK

GOOD

BAD