User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
44
7. Set the Platen to a safe clearance
Use the Platen to Head Clearance Adjustment Screen
on the User Interface to set the clearance of
approximately 3 mm (1/8”) and no less.
On the UI, press the “RIGHT hand” button until
•
the Mode Select screen appears. (Refer to the
previous chapter for details on UI screens)
In the upper left hand corner is a virtual dial
•
pointing to “Auto.” Press the dial once and it will
rotate to Manual.
• On the UI, browse through the screens until you come to
the Platen to Head Clearance Adjust (PHCA) screen.
Use the UP/DOWN arrows to set a Print Head clearance of
•
approximately 3 mm. What moves up and down is the Platen,
NOT the printer assembly. The UP button raises the Platen
closer to the Print Head and the DOWN button lowers the
Platen away from the Print Head.
• Make sure that the minimum 3mm distance is
maintained across the span of ALL THREE Shirt
Boards.
JOG
FOR. REV.
Use the JOG section of the
MMMU screen to manually
move the assembly to the
other Shirt Board positions.
Return the Print Carriage
8.
After a safe distance has been established, slide the Print Carriage back to the capping station. It will
click back into place.
9. Return to Home Position
Return to the UI and the MMMU screen. Under the Position
heading, press Home. The Printer Assembly will begin to move.
When it stops, it will be in the Home position.
ALWAYS KEEP
CLEARANCE OVER
3 MILLIMETERS
3mm
PLATEN
(PRINT BED)
PRINT HEAD
JOG
FOR. REV. HOME INDEXNEST
POSITION