User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
42
5. Measure the Distance
Using a ruler or a jig, measure the distance between
the Shirt Board and the Print Head. You may need to
go to the rear of the printer to see; you may also need
a ashlight.
In the photo to the right we used 3 CDs stacked
together (measuring 4 mm) to show how a jig can help
in the measuring process.
6. Adjust Shirt Board Corner Height (if needed)
If you determined that the Shirt Board needs to be raised or lowered in a
particular corner, the Blazer Express Shirt Boards have adjustment
screws located on the inside of the Shirt Board.
NOTE: If the Shirt Board adjustment screws cannot go any higher or lower, you
may have to raise or lower the entire Print Bed Assembly height using the Platen to
Head Adjustment screen on the User Interface to accommodate the Shirt Board’s
distance. For example: if 1 or more corners need to be raised or lowered an inch,
then rst raise or lower the entire height of the Print Bed Assembly one inch and
continue the leveling process. Refer to the next section, Adjusting the Overall
Height of the Print Bed Assembly. If Shirt Board is extremely out of level, refer to
Chapter 15 - Troubleshooting for solutions.
Repeat
7.
Repeat Steps 3 to 5 (and 6 if adjustments are needed) for every corner to complete the leveling
process. Also, repeat these steps for the other Shirt Boards that you will be utilizing (2 oversized, and
1 standard).
Return the Print Carriage
8.
Manually move the Print Carriage back to the Capping Station. It will click into place.
9. Return to Home Position
Return to the UI and the MMMU screen. Under the Position
heading, press Home. The Printer Assembly will begin to move.
When it stops, it will be in the Home position.
JOG
FOR. REV. HOME INDEXNEST
POSITION