User`s manual

Chapter 8 - Initialization Utilities
41
IF YOU HAVE COMPLETED A HEAD CLEANING CYCLE OR HAVE CONFIRMED THAT THE
PRINTER IS IN PRINTING POSITION, CONTINUE TO THE NEXT STEP.
3. Position the Shirt Board
You will need to position the rst Shirt Board underneath the Print
Head so that you can accurately measure the distance between the
two. The distance needs to be checked (and adjusted if necessary)
on all 4 corners of each Shirt Board to have the best possible
prints.
NOTE: Start out leveling the
Over-sized Shirt Boards (front
and back ends) and 1 Standard
Board (placed in the middle) as shown. This layout is needed
for the following Print Head Alignment section.
Also, after leveling a Shirt Board, make sure you mark it in a way that you can tell which
position and setting it needs to sit in for future use.
• Go to the UI and switch to Manual Mode
on the Mode Select screen. Refer to
Chapter 6 for details on UI screens.
• Next, go to the MMMU Screen and press
the FOR button to move the Platen incrementally towards the
printer assembly. Stop when the Shirt Board is lined up with
where the Print Head is. On the UI, touch the screen to get to the
Mode Select screen. Refer to Chapter 6 for details on UI screens.
Release the Print Carriage for Access
4.
The Print Carriage needs to be released in order to pull move it away from the capping station.
WARNING: BE VERY CAREFUL WHEN MOVING THE Print Head! DO NOT
LET THE Print Head TOUCH ANY SURFACE! THIS WILL PERMANENTLY
DAMAGE IT!
• Lift the printer cover (if it is not already lifted) and locate the
Carriage Release button (blue) located in front of the Print
Carriage on the right side of the printer.
Press down and slowly move the
• Print Carriage towards the
Shirt Board.
Over-sized
Shirt Board
Stand.
Shirt
Board
Over-sized
Shirt Board
MODE SELECT
AUTO
MANUAL
Pad
Enabled
MANUAL MECHANISM MOVEMENT UTILITY
JOG
FOR. REV. HOME INDEXNEST
POSITION