User`s manual

Chapter 8 - Initialization Utilities

• Lift the printer cover (if it is not already lifted) and locate the

Carriage Release Button (blue) located in front of the Print

Carriage on the right side of the printer.

Press down and slowly move the

• Print Carriage towards the

Shirt Board.

5. Measure the Distance

Using a ruler or a jig, measure the distance between

the Shirt Board and the Print Head. You may need to

go to the rear of the printer to see; you may also need

a ashlight.

In the photo to the right we used 3 CDs stacked

together (measuring 4 mm) to show how a jig can

help in the measuring process.

6. Adjust Shirt Board Corner Height (if needed)

If you determined that the Shirt Board needs to be raised or lowered in a

particular corner, the Blazer Express Shirt Boards have adjustment

screws located on the inside of the Shirt Board.

NOTE: If the Shirt Board adjustment screws cannot go

any higher or lower, you may have to raise or lower the

entire Print Bed Height using the Height Adjustment Knob

to accommodate the Shirt Board’s distance. For example: if

1 or more corners need to be raised or lowered an inch, then

rst raise or lower the entire height of the Print Bed one inch

and continue the leveling process.

Repeat

Repeat Steps 3 to 5 (and 6 if adjustments are needed) for every corner

to complete the leveling process. Also, repeat these steps for the other Shirt Boards (you can do this

later if desired).

Return the Print Carriage

Manually move the Print Carriage back to the Capping Station. It will click into place.

9. Return to Home Position

Return to the UI and the MMMU screen. Under the Position

heading, press Home. The Printer Assembly will begin to move.

When it stops, it will be in the Home position.

Turning the knob clockwise will

lower the Shirt Board, giving more

clearance and turning it counter-

clockwise will raise the Shirt Board,

giving less clearance.

JOG

FOR. REV. HOME INDEXNEST

POSITION