User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
36
• 2. The other method is to
visually check the gear that
controls the Print Head
height. This gear is on the
left end of the printer
opposite of the capping
station and can be viewed
by lifting the lid.
IF YOU HAVE COMPLETED
A HEAD CLEANING CYCLE
OR HAVE CONFIRMED THAT
THE PRINTER IS IN PRINTING
POSITION, CONTINUE TO STEP 3 BELOW.
3. Position the Shirt Board
You will need to position the Shirt Board underneath the Print
Head so that you can accurately measure the distance between the
two. The distance needs to be checked (and adjusted if necessary)
on all 4 corners to have the best possible prints. NOTE: Start out
leveling the Over-sized Shirt Board. It is needed for the
following sections - Nozzle Check and Print Head Alignment.
Also, after leveling a Shirt Board, make sure you mark it in a
way that you can tell which position it needs to sit in for future
use.
• Go to the UI and switch to Manual Mode
on the Mode Select screen. Refer to
Chapter 6 for details on UI screens.
• Next, go to the MMMU Screen and press the FOR button to
move the Shirt Board incrementally towards the printer
assembly. Stop when the Shirt Board is lined up with where the
Print Head is.
Release the Print Carriage for Access
4.
The Print Carriage needs to be released in order to pull move it away from the capping station.
WARNING: BE VERY CAREFUL WHEN MOVING THE Print Head! DO NOT
LET THE Print Head TOUCH ANY SURFACE! THIS WILL PERMANENTLY
DAMAGE IT!
DEFAULT POSITION:
If the gear is open like above, DO NOT
attempt to set the Print Head Height. The
easiest way to set this to Printing Position
is by performing a Head Cleaning Cycle.
PRINTING POSITION:
If the gear is closed like above, it is in
the correct position to set the Print Head
Height. Continue on with the next step.
MODE SELECT
AUTO
MANUAL
Pad
Enabled
MANUAL MECHANISM MOVEMENT UTILITY
JOG
FOR. REV. HOME INDEXNEST
POSITION