User`s manual

T-Jet Blazer Series User’s Manual

Version 5.0 Revised September, 2008

Pressing the DOWN button lowers the Platen (Print Bed) giving more clearance. •

The distance of the platen (with the substate loaded) needs to be set to a minimum of 3mm to a maximum

of 5mm in relation to the Printer Assembly. This distance will depend on what distance is used in

performing your Print Head Alignment. Learn more in Chapter 8 - Initialization Utilities.

System Printer Control Utility (SPCU) Screen

The SPCU has been discontinued. Your printer may or may not

have this screen available, but if so, the functions on this screen

should be utilized from the LCD Display Control Panel rather than

here.

To Reset a job or clear all jobs on the LCD Display Controls, press

and hold the Pause Button for 3 seconds.

To Pause a job on t he LCD Display Controls, press the Pause

Button.

The Alarm Select Screen

You may hear a tone when perfoming certain actions, such

as sending a print command. You will also notice blinking

of the green lights before and after printing. The Alarm

Select Screen allows you to control whether or not you

will hear or see these various audible and visual alarms.

Press any or both of the touch screen switches to turn the

alarms either on or off.

NOTE: To adjust these settings ensure the virtual dial on

the Mode Select Screen is set to Manual.

IMPORTANT POINT

Anytime you choose the Manual mode from the Mode Select Screen, you must

remember to return to that screen and switch the virtual dial to Auto to enable

printing.