User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
32
Pass Select: Press the number of desired passes in the Pass Select area of the Mode Select screen. this
will only work when in Auto Mode.
Pad Enabled Icon: The Pad Enabled icon will appear on all of the User Interface screens and represents
the mode that the Mode Select screen is set to. If the Pad Enabled is lit in red, the User Interface is in
Auto Mode and if not lit, is in Manual Mode.
IMPORTANT POINT
You MUST be in Manual mode to utilize any functions on the UI or perform any
Maintenance Utilities such as Head Cleanings, Head Alignments, etc. To Print, you
MUST be in Auto mode.
The Manual Mechanism Movement Utility (MMMU) Screen
The MMMU Screen controls the movements of the Blazer EXPRESS Print Bed and The Blazer PRO
Printer Assembly, prior to and after completion of a printing job. The MMMU Screen controls the
movement of the Printer Assembly prior to and after completion of a printing job. These movement
functions are also used when performing certain maintenance utilities. The Assembly has three preset
positions and these are listed under the heading “Position”: Home, Nest and Index. Since the two Blazer
models work a bit different, some of the following sections
have been separated by model to prevent confusion.
Home Button:
BLAZER EXPRESS
Pressing and holding the Home Button for 2 seconds will eject
the Print Bed all the way to the front of the printer. From this
position you may load or remove garments.
Home Button:
BLAZER PRO
Pressing and holding the Home Button for 2 seconds will send
the Printer Assembly all the way to the back of the printer.
From this position you may load or remove garments by pulling the platen handle out.
Index Button:
BLAZER EXPRESS
Pressing and holding the Index Button for 2 seconds will move the Print Bed to the rear of the printer.
When in this position, you may perform various maintenance functions such as Nozzle Checks, Head
Alignments, etc.
Index Button:
BLAZER PRO
Pressing and holding the Index Button for 2 seconds will move the Printer Assembly towards the center
of the Print Bed. When in this position, you may perform various maintenance functions such as Nozzle
Checks, Head Alignments, etc.
Nest Button: Pressing and holding the Nest Button for 2 seconds will move the Printer Assembly
(PRO) or Print Bed (EXPRESS) forward or backward and align it with the front sensor. No printing or
maintenance functions should be performed from this position. This is ONLY to check the functionality of
the sensor.