User`s manual

Chapter 7 - Learning the LCD and User Interface Controls
31
About the User Interface Buttons
The T-Jet Blazer EXPRESS and the PRO both feature a User Interface (also referred to as HMI). The
User Interface (UI) allows power and control of the printer assembly and has 3 main buttons (not counting
the touch screen display).
Power Off Button
This button is used to shutdown the
printer assembly during a normal
shutdown cycle. For the Blazer PRO
model is also used as an emergency shutdown.
The Blazer EXPRESS has an emergency
shutdown located on the front left side of the
machine.
Power On Button
This button is used to power on the
Printer Assembly after the main
power has been turned on.
Send Print Button
The green “send print” button(s) are used to send a print job. The PRO model has 2 while the
EXPRESS model only has one. Press and hold the send print button(s) for a few seconds to send
the print.
User Interface Touch Screens
The User Interface also adds convenience and function, allowing you to perform several operations from
its touch screens rather than the LCD Control Panel. Each screen is touch sensitive, allowing you to
navigate between screens or change screen settings with a touch of a nger. The opening screen is referred
to as the Home Screen. Press the screen to begin navigation. Navigate by using the Left and Right arrows.
Throughout the navigation process, return to the home screen by pressing the Home icon.
The Mode Select Screen
The Mode Select Screen allows the selection of two modes
using the selection dial. The mode select screen also
allows the selection of the amount of print passes desired.
Manual Mode: Using the selection dial to select Manual
will allow you to perform Maintenance Utilities and
control nite movements of the printer.
Auto Mode: Using the selection dial to select Auto
will change tht mode to Auto Mode (or printing mode)
allowing you to print and select print passes. If printing,
you must be in Auto Mode.