User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
18
Overview of Printer Connections
Plugging the Unit into AC Power
Plug the printer into its own power source. The T-Jet Blazer Express has a dual voltage power converter
built in, allowing it to work with 50 or 60 cycle current ranging from 110 volts to 220 volts.
Insert the AC cord into the unit and plug the opposite end into a power strip with surge protection. Avoid
plugging multiple items into the same power strip.
For more reliable results, plug the unit into a UPS (Uninterrupted Power Supply) to help prevent ruined
shirts during power uctuations. DO NOT plug other high power use items, such as a Heat Press, into the
same circuit.
Powering the Blazer EXPRESS ON and
OFF
Always Power On and Off as stated below. Your printer requires a proper startup and shutdown cycle that
may only run if the following steps are followed correctly.
Powering On
Power On the Main Switch1.
When turning ON your printer, you must rst turn on
the Main Power Switch on the rear of the printer, located
adjacent the AC cord. Move to the up position.
Main Power Switch
Power Switch
AC Power Cord Plug-In
USB Connection
ON
OFF