User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
10
Casters have been built into the cabinet base, allowing for easy movement to a suitable location within
your shop. When determining where to set up your printer, keep in mind the T-Jet Blazer Pro requires an
area of at least 12 ft x 10 ft (3.65 m x 3 m) for the printer and workspace around it. Additional space is
required for drying, pretreating garments, garment staging, etc.
Note: Remove any obstacles. All doorways and corridors the printer will travel through must be at least
36 inches (92 cm) wide.
Setting the Ground Supports
When the Blazer Pro reaches its nal
destination, manually lower the ground
supports on all four corners. Using a box
level (found at any hardware store), check
the Print Bed to ensure it and the machine
are level. Each ground support is threaded
and can be raised or lowered to make any
needed height adjustments. Once you have
leveled the machine, tighten each locking
nut against the bottom of the cabinet base.
Installing the User Interface
The User Interface (UI) controls basic printer operation and is
touch sensitive. To install the UI you will need a 5mm Allen
wrench
1. Unpack the User Interface and locate the (2) 5mm hex screws
for installation.
Position the extension
2.
bracket along the back of the
machine as shown. Using
the Allen wrench, secure
the extension bracket to the
printer base.
3. Connect the UI Serial Port Cable to the cabinet
base. It is located just to the right of the USB port.
Ground Support
Locking Nut